Yes, the hub is identical
Same 5x139.7 PCD and same 78.1 mm centre bore: wheels from Dodge Durango bolt on and centre on Chrysler Aspen without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Dodge Durango is compared with the one from Chrysler Aspen of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈7.5Jx17 ET26 · 245/70R17 — Check on the car
Compared with the original ≈7.5Jx17 ET35 on Chrysler Aspen: shock absorber side −9 mm, wheel arch side +9 mm, tyre diameter +0 %.
Comparison for guidance only (estimated width). Check in detail
- ?
≈8.5Jx18 ET48 · 265/60R18
Chrysler Aspen has no 18-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Chrysler Aspen (Ecrous - 9/16 - 18 U), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Chrysler Aspen on Dodge Durango?