Yes, the hub is identical
Same 5x108 PCD and same 63.4 mm centre bore: wheels from Ford Kuga III bolt on and centre on Land Rover Range Rover Velar without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Ford Kuga III is compared with the one from Land Rover Range Rover Velar of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
7.5Jx18 ET50 · 225/60R18 — Check on the car
Compared with the original 7.5Jx18 ET45 on Land Rover Range Rover Velar: shock absorber side +5 mm, wheel arch side −5 mm, tyre diameter −4.7 % : fit it with the original tyre size of Land Rover Range Rover Velar (235/65R18), not that of Ford Kuga III.
Check in detail
- ?
7Jx17 ET50 · 225/65R17
Land Rover Range Rover Velar has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Land Rover Range Rover Velar (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Land Rover Range Rover Velar on Ford Kuga III?