Yes, the hub is identical
Same 4x98 PCD and same 58.1 mm centre bore: wheels from Lada 1200 bolt on and centre on Fiat Panda I without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Lada 1200 is compared with the one from Fiat Panda I of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈5Jx13 ET29 · 155/80R13 — Check on the car
Compared with the original ≈5Jx13 ET35 on Fiat Panda I: shock absorber side −6 mm, wheel arch side +6 mm, tyre diameter +0 %.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Fiat Panda I (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Fiat Panda I on Lada 1200?