FRENES

Wheels from Lancia Delta III on Abarth 500e: compatible?

Yes, the hub is identical

Same 4x98 PCD and same 58.1 mm centre bore: wheels from Lancia Delta III bolt on and centre on Abarth 500e without rings. You still need to check the offset and tyres, detailed below.

Lancia Delta III2008–2014Abarth 500efrom 2023
PCD4x984x98
Centre bore58.1 mm58.1 mm
ThreadM12x1.25M12x1.25
Original wheels 7Jx16 ET31
7Jx17 ET31		 ≈6.5Jx17 ET40

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Lancia Delta III is compared with the one from Abarth 500e of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 7Jx17 ET31 · 225/45R17 — Check on the car

    Compared with the original ≈6.5Jx17 ET40 on Abarth 500e: shock absorber side −2.7 mm, wheel arch side +15.4 mm, tyre diameter +2.9 % : fit it with the original tyre size of Abarth 500e (205/45R17), not that of Lancia Delta III. Comparison for guidance only (estimated width). Check in detail

  • 7Jx16 ET31 · 205/55R16

    Abarth 500e has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Abarth 500e (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Abarth 500e on Lancia Delta III?