Yes, the hub is identical
Same 5x114.3 PCD and same 66.1 mm centre bore: wheels from Nissan Juke II bolt on and centre on Renault Scenic E-Tech without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Nissan Juke II is compared with the one from Renault Scenic E-Tech of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
7.5Jx19 ET35 · 225/45R19 — Check on the car
Compared with the original 7.5Jx19 ET46 on Renault Scenic E-Tech: shock absorber side −11 mm, wheel arch side +11 mm, tyre diameter −3.2 % : fit it with the original tyre size of Renault Scenic E-Tech (205/55R19), not that of Nissan Juke II.
Check in detail
- ?
6.5Jx16 ET35 · 215/65R16
Renault Scenic E-Tech has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.
- ?
7Jx17 ET35 · 215/60R17
Renault Scenic E-Tech has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Renault Scenic E-Tech (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Renault Scenic E-Tech on Nissan Juke II?