FRENES

Wheels from Nissan NV250 on Mercedes Citan: compatible?

No, the centre bore is too small

Same 5x108 PCD, but the centre bore of the wheels from Nissan NV250 (60.1 mm) is smaller than the hub of Mercedes Citan (66.1 mm): they will not fit without being re-bored by a professional.

Nissan NV2502019–2022Mercedes Citanfrom 2012
PCD5x1085x108 / 5x114.3
Centre bore60.1 mm66.1 mm
ThreadM12x1.50M12x1.50
Original wheels 6Jx15 ET44 5.5Jx14 ET44
≈6Jx15 ET38

≈: width estimated from the original tyre size.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mercedes Citan (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Mercedes Citan on Nissan NV250?