FRENES

Wheels from Peugeot 807 on Holden Combo: compatible?

Yes, the hub is identical

Same 5x98 PCD and same 58.1 mm centre bore: wheels from Peugeot 807 bolt on and centre on Holden Combo without rings. You still need to check the offset and tyres, detailed below.

Peugeot 807from 2002Holden Combofrom 2011
PCD5x985x98
Centre bore58.1 mm58.1 mm
ThreadM14x1.50M12x1.25
Original wheels ≈6.5Jx15 ET31 ≈6Jx15 ET39

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Peugeot 807 is compared with the one from Holden Combo of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈6.5Jx15 ET31 · 205/65R15 — Check on the car

    Compared with the original ≈6Jx15 ET39 on Holden Combo: shock absorber side −1.6 mm, wheel arch side +14.4 mm, tyre diameter +4.2 % : fit it with the original tyre size of Holden Combo (185/65R15), not that of Peugeot 807. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Holden Combo (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Holden Combo on Peugeot 807?