Yes, the hub is identical
Same 5x100 PCD and same 57.1 mm centre bore: wheels from Skoda Kamiq GT bolt on and centre on MG ZS without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Skoda Kamiq GT is compared with the one from MG ZS of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6.5Jx16 ET34 · 205/60R16 — Check on the car
Compared with the original ≈6.5Jx16 ET45 on MG ZS: shock absorber side −11 mm, wheel arch side +11 mm, tyre diameter +6.7 % : fit it with the original tyre size of MG ZS (205/50R16), not that of Skoda Kamiq GT.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of MG ZS (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from MG ZS on Skoda Kamiq GT?