FRENES

Wheels from Skoda Kamiq on Audi A1: compatible?

Yes, the hub is identical

Same 5x100 PCD and same 57.1 mm centre bore: wheels from Skoda Kamiq bolt on and centre on Audi A1 without rings. You still need to check the offset and tyres, detailed below.

Skoda Kamiqfrom 2019Audi A12010–2018
PCD5x1005x100
Centre bore57.1 mm57.1 mm
ThreadM14x1.50M14x1.50
Original wheels ≈6Jx15 ET38 6Jx15 ET29
≈6Jx15 ET40

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Skoda Kamiq is compared with the one from Audi A1 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈6Jx15 ET38 · 195/65R15 — Check on the car

    Compared with the original 6Jx15 ET29 on Audi A1: shock absorber side +9 mm, wheel arch side −9 mm, tyre diameter +5.2 % : fit it with the original tyre size of Audi A1 (185/60R15), not that of Skoda Kamiq. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Audi A1 (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Audi A1 on Skoda Kamiq?