Yes, the hub is identical
Same 5x115 PCD and same 71.6 mm centre bore: wheels from Dodge Challenger bolt on and centre on Chrysler 300C without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Dodge Challenger is compared with the one from Chrysler 300C of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈7Jx18 ET24 · 225/60R18 — Check on the car
Compared with the original ≈7Jx18 ET30 on Chrysler 300C: shock absorber side −6 mm, wheel arch side +6 mm, tyre diameter +0 %.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Chrysler 300C (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Chrysler 300C on Dodge Challenger?