FRENES

Wheels from Honda Life Dunk on Mitsubishi Colt: compatible?

No, the centre bore is too small

Same 4x100 PCD, but the centre bore of the wheels from Honda Life Dunk (56.1 mm) is smaller than the hub of Mitsubishi Colt (67.1 mm): they will not fit without being re-bored by a professional.

Honda Life Dunk2000–2003Mitsubishi Colt1988–1992
PCD4x1004x114.3 / 4x100
Centre bore56.1 mm67.1 mm
ThreadEcrous - 12x1.50Ecrous - 12x1.50
Original wheels ≈5Jx13 ET40 ≈5.5Jx13 ET46
≈5.5Jx14 ET46
≈6Jx14 ET46
≈6Jx15 ET46
≈6Jx16 ET37

≈: width estimated from the original tyre size.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mitsubishi Colt (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Mitsubishi Colt on Honda Life Dunk?