Yes, the hub is identical
Same 5x114.3 PCD and same 71.6 mm centre bore: wheels from Jeep Wrangler bolt on and centre on Dodge Nitro without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Jeep Wrangler is compared with the one from Dodge Nitro of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈7.5Jx17 ET44 · 245/75R17 — Check on the car
Compared with the original ≈7.5Jx17 ET39 on Dodge Nitro: shock absorber side +5 mm, wheel arch side −5 mm, tyre diameter +6.5 % : fit it with the original tyre size of Dodge Nitro (245/65R17), not that of Jeep Wrangler.
Comparison for guidance only (estimated width). Check in detail
- ?
≈7Jx16 ET51 · 225/75R16
Dodge Nitro has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Dodge Nitro (Ecrous - 1/2 - 20 UN), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Dodge Nitro on Jeep Wrangler?