Yes, the hub is identical
Same 5x114.3 PCD and same 71.6 mm centre bore: wheels from TVR Cerbera bolt on and centre on Dodge Nitro without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from TVR Cerbera is compared with the one from Dodge Nitro of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7.5Jx17 ET40 · 235/45R17 — Fits like the original
Compared with the original ≈7.5Jx17 ET39 on Dodge Nitro: shock absorber side +1 mm, wheel arch side −1 mm, tyre diameter −14.3 % : fit it with the original tyre size of Dodge Nitro (245/65R17), not that of TVR Cerbera.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Dodge Nitro (Ecrous - 1/2 - 20 UN), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Dodge Nitro on TVR Cerbera?