Yes, the hub is identical
Same 4x114.3 PCD and same 67.1 mm centre bore: wheels from Mazda RX-7 bolt on and centre on Mitsubishi Lancer without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Mazda RX-7 is compared with the one from Mitsubishi Lancer of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6Jx13 ET20 · 185/70R13 — Check on the car
Compared with the original ≈5.5Jx13 ET45 on Mitsubishi Lancer: shock absorber side −18.7 mm, wheel arch side +31.4 mm, tyre diameter +2.4 % : fit it with the original tyre size of Mitsubishi Lancer (175/70R13), not that of Mazda RX-7.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mitsubishi Lancer (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Mitsubishi Lancer on Mazda RX-7?