Yes, the hub is identical
Same 5x100 PCD and same 56.1 mm centre bore: wheels from MG ZS II bolt on and centre on Toyota GR86 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from MG ZS II is compared with the one from Toyota GR86 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
7Jx17 ET41 · 215/55R17 — Fits like the original
Compared with the original 7.5Jx17 ET48 on Toyota GR86: shock absorber side −13.4 mm, wheel arch side +0.6 mm, tyre diameter +6.9 % : fit it with the original tyre size of Toyota GR86 (215/45R17), not that of MG ZS II.
Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Toyota GR86 (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Toyota GR86 on MG ZS II?