Yes, the hub is identical
Same 5x100 PCD and same 56.1 mm centre bore: wheels from Toyota GR86 bolt on and centre on MG ZS II without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Toyota GR86 is compared with the one from MG ZS II of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✕
7.5Jx17 ET48 · 215/45R17 — Risk of rubbing
Compared with the original 7Jx17 ET41 on MG ZS II: shock absorber side +13.4 mm, wheel arch side −0.6 mm, tyre diameter −6.4 % : fit it with the original tyre size of MG ZS II (215/55R17), not that of Toyota GR86.
Check in detail
- ?
7.5Jx18 ET48 · 215/40R18
MG ZS II has no 18-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of MG ZS II (M14x1.5), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from MG ZS II on Toyota GR86?