Yes, the hub is identical
Same 5x130 PCD and same 89.1 mm centre bore: wheels from Nissan NV400 bolt on and centre on Renault Master 4 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Nissan NV400 is compared with the one from Renault Master 4 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
6.5Jx16 ET66 · 215/65R16 — Check on the car
Compared with the original 6Jx16 ET66 on Renault Master 4: shock absorber side +6.4 mm, wheel arch side +6.4 mm, tyre diameter −3.9 % : fit it with the original tyre size of Renault Master 4 (205/75R16), not that of Nissan NV400.
Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Renault Master 4 (M14x1.5), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Renault Master 4 on Nissan NV400?