Yes, the hub is identical
Same 5x108 PCD and same 60.1 mm centre bore: wheels from Omoda 5 bolt on and centre on Jaecoo 7 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Omoda 5 is compared with the one from Jaecoo 7 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
7Jx18 ET33 · 215/55R18 — Check on the car
Compared with the original 7.5Jx18 ET47 on Jaecoo 7: shock absorber side −20.4 mm, wheel arch side +7.6 mm, tyre diameter −3.1 % : fit it with the original tyre size of Jaecoo 7 (235/55R18), not that of Omoda 5.
Check in detail
- ?
6.5Jx17 ET33 · 215/60R17
Jaecoo 7 has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Jaecoo 7, tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Jaecoo 7 on Omoda 5?