Yes, the hub is identical
Same 5x108 PCD and same 60.1 mm centre bore: wheels from Jaecoo 7 bolt on and centre on Omoda 5 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Jaecoo 7 is compared with the one from Omoda 5 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✕
7.5Jx18 ET47 · 235/55R18 — Risk of rubbing
Compared with the original 7Jx18 ET33 on Omoda 5: shock absorber side +20.4 mm, wheel arch side −7.6 mm, tyre diameter +3.2 % : fit it with the original tyre size of Omoda 5 (215/55R18), not that of Jaecoo 7.
Check in detail
- ?
7Jx19 ET47 · 235/50R19
Omoda 5 has no 19-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Omoda 5 (M12x1.5), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Omoda 5 on Jaecoo 7?