A Land Rover Discovery I (1991–1998) uses a 5x165.1 PCD and a centre bore of 124 mm.
Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.
Centre bore: the wheel must have a centre bore of 124 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 124 mm.
Offset: the original is ET33. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
Fixings: thread Ecrous - 16x1.50, tightened to 129 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.
Vehicles with the same PCD and centre bore
Same 5x165.1 PCD and same 124 mm centre bore: wheels from these vehicles bolt on and centre on a Land Rover Discovery I without rings. Offset, width, diameter and caliper clearance still need checking.
Will wheels from another vehicle fit your Discovery I?
Choose the vehicle the wheels come from: we compare the hub, then each original wheel to the millimetre.
Same PCD, different centre bore
These vehicles also use 5x165.1 but with a different centre bore: their wheels need a hub centric ring if their centre bore is larger than 124 mm, and will not fit if it is smaller.
A Land Rover Discovery I (1991–1998) has a PCD of 5x165.1: 5 studs or bolts spaced around a circle 165.1 mm in diameter.
Does a Land Rover Discovery I need a hub centric ring?
The centre bore (hub diameter) of a Land Rover Discovery I is 124 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.
What offset (ET) for a Land Rover Discovery I?
The recorded original offset is ET33. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.
What tightening torque for the wheels of a Land Rover Discovery I?
The specified tightening torque is 129 Nm for Ecrous - 16x1.50 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.
Which vehicles have the same PCD as a Land Rover Discovery I?
With the same PCD (5x165.1) and the same centre bore (124 mm), these include: Land Rover Range Rover I. Offset, width and rim diameter still need checking for each vehicle.
Does a value look wrong, or is a version missing? Let us know, we check every report.
Cookies : we use audience measurement cookies (Google Analytics) and, if you accept, advertising cookies. You can change your mind at any time via “Manage cookies” at the bottom of the page. Learn more