Yes, the hub is identical
Same 5x114.3 PCD and same 71.6 mm centre bore: wheels from Dodge Nitro bolt on and centre on TVR Cerbera without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Dodge Nitro is compared with the one from TVR Cerbera of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7.5Jx17 ET39 · 245/65R17 — Fits like the original
Compared with the original ≈7.5Jx17 ET40 on TVR Cerbera: shock absorber side −1 mm, wheel arch side +1 mm, tyre diameter +16.6 % : fit it with the original tyre size of TVR Cerbera (235/45R17), not that of Dodge Nitro.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of TVR Cerbera (-), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from TVR Cerbera on Dodge Nitro?