Audi RS2 PCD

1994–1996

VERIFIED

Centre bore72.6 mm

Offset (ET)ET52

Fixing typeM14x1.50

Tightening torque130 Nm

Hub centric rings 72.6 mm → Wheel spacers 5x130(partner link) Change PCD (PCD adapter)(partner link) Sheet for your mechanic

Fitting wheels on a Audi RS2

A Audi RS2 (1994–1996) uses a 5x130 PCD and a centre bore of 72.6 mm. Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.

PCD: 5x130 required. See all vehicles with 5x130.
Centre bore: the wheel must have a centre bore of 72.6 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 72.6 mm.
Offset: the original is ET52. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
Fixings: thread M14x1.50, tightened to 130 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.

Will wheels from another vehicle fit your RS2?

Choose the vehicle the wheels come from: we compare the hub, then each original wheel to the millimetre.

Make

Model

Same PCD, different centre bore

These vehicles also use 5x130 but with a different centre bore: their wheels need a hub centric ring if their centre bore is larger than 72.6 mm, and will not fit if it is smaller.

Audi Q7 V12TDI ⌀71.5 Audi Q7 ⌀71.6 Mercedes G-Classe W465 ⌀84.1 Bugatti Centodieci ⌀71.6 Bugatti Mistral ⌀71.6 Maxus EV80 Plus ⌀78.1 Maxus EV80 Pro ⌀78.1 Faw - Hongqi E-HS9 ⌀71.6

Frequently asked questions

What is the PCD of a Audi RS2?

A Audi RS2 (1994–1996) has a PCD of 5x130: 5 studs or bolts spaced around a circle 130 mm in diameter.

Does a Audi RS2 need a hub centric ring?

The centre bore (hub diameter) of a Audi RS2 is 72.6 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.

What offset (ET) for a Audi RS2?

The recorded original offset is ET52. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.

What tightening torque for the wheels of a Audi RS2?

The specified tightening torque is 130 Nm for M14x1.50 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.

Other Audi models

Q4 E-TRON 5x112 A3 8Y 5x112 RS6 C8 5x112 RS Q8 5x112 A1 Citycarver 5x100 SQ8 5x112 RS Q3 5x112 S6 C8 5x112 A4 5x112 SQ2 5x112 A7 5x112 E-Tron 5x112 All Audi →

Does a value look wrong, or is a version missing? Let us know, we check every report.