A Peugeot Expert III (from 2016) uses a 5x108 PCD and a centre bore of 65.1 mm.
Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.
Centre bore: the wheel must have a centre bore of 65.1 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 65.1 mm.
Offset: the original is ET46. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
Fixings: thread M12x1.25, tightened to 115 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.
Tyres: original fitment is 215/65R16, 215/60R17, 225/55R17. For another size, check the diameter difference with the equivalence calculator (under 3 % recommended).
Generations of the Peugeot Expert
Previous generation: Peugeot Expert 2 (2006–2016) — same 5x108 bolt pattern and same centre bore: original wheels swap between the two generations; check offset and diameter.
Same 5x108 PCD and same 65.1 mm centre bore: wheels from these vehicles bolt on and centre on a Peugeot Expert III without rings. Offset, width, diameter and caliper clearance still need checking.
These vehicles also use 5x108 but with a different centre bore: their wheels need a hub centric ring if their centre bore is larger than 65.1 mm, and will not fit if it is smaller.
A Peugeot Expert III (from 2016) has a PCD of 5x108: 5 studs or bolts spaced around a circle 108 mm in diameter.
Does a Peugeot Expert III need a hub centric ring?
The centre bore (hub diameter) of a Peugeot Expert III is 65.1 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.
What offset (ET) for a Peugeot Expert III?
The recorded original offset is ET46 depending on the version and wheel size. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.
What tightening torque for the wheels of a Peugeot Expert III?
The specified tightening torque is 115 Nm for M12x1.25 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.
Which vehicles have the same PCD as a Peugeot Expert III?
With the same PCD (5x108) and the same centre bore (65.1 mm), these include: Peugeot 3008 III, Peugeot 408, Peugeot 308 III, Peugeot 508 II. Offset, width and rim diameter still need checking for each vehicle.
Does a value look wrong, or is a version missing? Let us know, we check every report.
Cookies : we use audience measurement cookies (Google Analytics) and, if you accept, advertising cookies. You can change your mind at any time via “Manage cookies” at the bottom of the page. Learn more