A Daihatsu Mira Gino (from 2006) uses a 4x100 PCD and a centre bore of 54.1 mm.
Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.
Centre bore: the wheel must have a centre bore of 54.1 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 54.1 mm.
Offset: the original is ET40. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
Fixings: thread Ecrous - 12x1.50, tightened to 103 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.
Vehicles with the same PCD and centre bore
Same 4x100 PCD and same 54.1 mm centre bore: wheels from these vehicles bolt on and centre on a Daihatsu Mira Gino without rings. Offset, width, diameter and caliper clearance still need checking.
Will wheels from another vehicle fit your Mira Gino?
Choose the vehicle the wheels come from: we compare the hub, then each original wheel to the millimetre.
Same PCD, different centre bore
These vehicles also use 4x100 but with a different centre bore: their wheels need a hub centric ring if their centre bore is larger than 54.1 mm, and will not fit if it is smaller.
A Daihatsu Mira Gino (from 2006) has a PCD of 4x100: 4 studs or bolts spaced around a circle 100 mm in diameter.
Does a Daihatsu Mira Gino need a hub centric ring?
The centre bore (hub diameter) of a Daihatsu Mira Gino is 54.1 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.
What offset (ET) for a Daihatsu Mira Gino?
The recorded original offset is ET40. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.
What tightening torque for the wheels of a Daihatsu Mira Gino?
The specified tightening torque is 103 Nm for Ecrous - 12x1.50 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.
Which vehicles have the same PCD as a Daihatsu Mira Gino?
With the same PCD (4x100) and the same centre bore (54.1 mm), these include: Daihatsu Materia, Daihatsu Trevis, Daihatsu Copen, Daihatsu YRV. Offset, width and rim diameter still need checking for each vehicle.
Does a value look wrong, or is a version missing? Let us know, we check every report.
Cookies : we use audience measurement cookies (Google Analytics) and, if you accept, advertising cookies. You can change your mind at any time via “Manage cookies” at the bottom of the page. Learn more